Lifesize Icon Guide 20
Recording with LifeSize UVC Video Center
With UVC Video Center configured in your environment, you can initiate a recording at any time.
To show video and audio statistics of the recording stream during recording, select using the phone or
> using the remote control.
Recording During a Call
Select to start recording during a call. If prompted, enter a valid recording key. If successful, the
recording begins and the recording icon appears.
By default, all callers are recorded. To record only the near or far video, change the default recording
layout in Preferences > Record and Stream.
To stop a recording, end the call or presentation, or select .
Recording Outside a Call
1. Select .
2. Select from one of the available recording options to start the recording session:
– Record input from the camera.
– Record input from the presentation.
– Record two streams: input from the presentation and camera.
– Record input from two cameras. Select or to select the camera that provides the primary
input. This option is available only with two connected cameras.
3. Select to start recording. If prompted, enter a valid recording key. If successful, the recording
begins and the recording icon appears.
4. Optional: If you are recording input from the camera or from a presentation, select to toggle the
input: presentation or camera. If you are recording two streams, select to toggle between recording
two streams (presentation and camera) and a single stream (camera).
5. To stop recording, select .
NOTE If you placed a call or started a presentation after the recording started, you
can stop the recording and the session by ending the call or presentation.
6. To end the recording session, select the appropriate option: , , , or , depending on your
selection in step 2.
To Next Page
Loading...
Need help?
General
