Lightware MMX4x2 Series

 MMX4x2 series – User's Manual 112


Setting the DHCP State
ATTENTION!  ApplySettings method

ApplySettings
Command and Response #dhcp #network #ipaddress
ç <dhcp_status>
æ <dhcp_status>
Parameters
If the <dhcp_status> parameter is true, the current IP address setting is DHCP, if the parameter is false, the
current IP address is static.
Example
ç 
æ 
ç 
æ 
INFO:  The ApplySettings method will save and apply the new value and will reboot the device.
INFO:  The current setting can be queried by the GET command.
Changing the IP Address (Static)
Command and Response
ç <IP_address>
æ <IP_address>
Example
ç 
æ 
ç 
æ 
INFO:  The ApplySettings method will save and apply the new value and will reboot the device.
INFO:  The current setting can be queried by the GET command.
Changing the Subnet Mask (Static)
Command and Response #ipaddress
ç <netmask>
æ <netmask>
Example
ç 
æ 
ç 
æ 
INFO:  The ApplySettings method will save and apply the new value and will reboot the device.
INFO:  The current setting can be queried by using the GET command.
Changing the Gateway Address (Static)
Command and Response
ç <gw_address>
æ <gw_address>
Example
ç 
æ 
ç 
æ 
INFO:  The ApplySettings method will save and apply the new value and will reboot the device.
INFO:  The current setting can be queried by using the GET command.
Applying Network Settings
Command and Response
ç 
æ 
Example
ç 
æ 
All network settings that are changed are applied and network interface restarts.



