MMX4x2 series – User's Manual 73
Viewing Installed Board
Shows the hardware name and revision of the installed cards.
Command and Response
{IS}
MB_DESC
Example
{is}
The device reports its motherboard (slot 0).
Connection Test
Simple test to see if the connection is established successfully.
Command and Response
{PING}
Example
{ping}
(PONG!)
Restarting the Device
The device can be restarted without unplugging power.
Command and Response #reboot #restart
{RST}
Example
{rst}
The device reboots; no response is sent in this case.
Compile Time
Command and Response
{CT}
Example
{ct}
Internal voltages and measured temperature values are shown.
Command and Response #status
{ST}
(ST·<DESC
Example
{st}
The device responds its 8-digit serial number; see the structure in the About the Serial Number section.
Command and Response #serialnumber
{S}
(SN:<
Example
{s}
Restoring the Factory Default Settings
Settings can be reset to factory default values as follows:
Command and Response #factory
Example
{factory=all}
All settings and parameters are reset to factory default, see the table in the Factory Default Settings section.
To Next Page
Loading...
