MMX4x2 series – User's Manual 80
General LW2 Commands
{i}
{F}
{FC}
{IS}
Connection Test
{PING}
Restarting the Device
{RST}
Compile Time
{CT}
{ST}
{S}
Restoring the Factory Default Settings
AV Port Settings
Switching an Input to the Outputs
{<in>@<out>•<layer>}
Muting an Output
{#<out>•<layer>}
Unmuting an Output
{+<out>•<layer>}
{#><out>•<layer>}
Unlocking an Output
{+<<out>•<layer>}
<layer>}
<layer>}
<out>=<state>;<mode>}
Setting the Audio Autoselect Mode
{AS_A<out>=<state>;<mode>}
<out>=<in1_prio>;<in2_prio>;…;<inn_prio>}
Setting the Audio Input Priorities
{PRIO_A<out>=<in1_prio>;<in2_prio>;…;<inn_prio>}
Setting the IP Address
{IP_ADDRESS=<type>;<ip_address>}
Setting the Subnet Mask
{IP_NETMASK=<subnet_mask>}
Setting the Gateway Address
<gateway_addr>}
Applying the Network Settings
{ip_apply}
<switch>}
To Next Page
Loading...
