Lightware MMX4x2 Series

 MMX4x2 series – User's Manual 136


ç <loc>.ExternalConditionTriggerCount
Testing an Action
ç <loc>:ActionTest(1)
Variable-Management

ç <loc><value>
Addition and Subtraction (Add Method)
ç <loc>:add(<operand>;<min>;<max>)
Addition and Subtraction (Cycle Method)
ç <loc>:cycle(<operand>;<min>;<max>)

ç <loc>:case(<min> <max> <val>;)
Scanning and Storing
ç <loc>:scanf(<path>.<property>;<pattern>)

ç <loc>:printf(%s)

Setting the DHCP State
ç <dhcp_status>
Changing the IP Address (Static)
ç <IP_address>
Changing the Subnet Mask (Static)
ç <netmask>
Changing the Gateway Address (Static)
ç <gw_address>
Applying Network Settings
ç 
Ethernet Tool Kit
Device Filter Based on MAC Address
ç <loc>=<MAC_address>;<receive>;<send>;<name>

ç <port_mode>
HTTP Port Blocking
ç <port_mode>
HTTP Post Receiving Blocking
ç <port_mode>

ç MAC_address)
Setting the Host Name
ç <unique_name>
Ethernet Message Sending
Sending a TCP Message (ASCII-format)
ç <IP_address>:<port_no>=<message>)
Sending a TCP Text (ASCII-format)
ç <IP_address>:<port_no>=<text>)
Sending a TCP Binary Message (HEX-format)
ç <IP_address>:<port_no>=<HEX_message>)
Sending a UDP Message (ASCII-format)
ç <IP_address>:<port_no>=<message>)
Sending a UDP Text (ASCII-format)
ç <IP_address>:<port_no>=<text>)
Sending a UDP Binary Message (HEX-format)
ç <IP_address>:<port_no>=<HEX_message>)
HTTP Messaging
Setting the Target IP Address
ç <IP_address>
Setting the TCP Port
ç <port_no>
Setting the Target Path
ç <path>
Setting the Message Header
ç <header_text>
Sending a Post Message
ç <body_text>)
Sending a Put Message
ç <body_text>)



