LINXON Safety | 2
LX218-Operating-Manual-en1-04-(1908) 11 / 90
Dangers from electric
power
There is a danger to life from the contact of conductive parts inside the device.
• Disconnect the device from the power supply prior to any installation and
maintenance work. Make sure that the electric power supply cannot reconnected
without authorization.
The device contains electric components that can be damaged from high electric
voltage.
• Before connecting the device to the power supply, make sure that the supply
voltage specified on the device is the same as the local power supply.
Explosion hazard
Hydrogen is a flammable and explosive gas.
• Use only tracer gases with a concentration of hydrogen that cannot explode in
combination with oxygen. The allowable composition of venal gas mixtures can be
read in the safety data sheets of the respective manufacturers.
Danger from suction
effect at the inlet flange
When operating the device in operation mode Vacuum there will be a negative
pressure created at the inlet flange.
The suction effect on hands or other body parts can cause injuries or trigger
uncontrolled movements from a person being frightened.
• Pay special attention to this danger when using a remote control!
• Connect the inlet flange with a test rig or seal it off using a blank flange.
Injury from bursting
objects
There is risk of injury from bursting objects causes by a test object notwithstanding the
vacuum pressure when a test object is connected.
• Take appropriate precautions.
Risk of injury from
slipping off or falling
down
• Place the device only on surfaces that are not tilted.
• Do not lift or carry the device by yourself.
To Next Page
Loading...