6 | Operation LINXON
38 / 90 LX218-Operating-Manual-en1-04-(1908)
As an alternative, you can also change
the operation mode in "Run-up > Test
settings > Operation mode & mass" and
switch between the detectable gases.
Run-up Here, you can adjust various settings for
the measurement tasks, as well as global
settings, e.g., changing the display or
editing permissions.
Select "Run-up > Configuration"
Calibration CAL This function is displayed if the calibration
is active in the "Access control" menu.
Select "Standby > Calibration"
Check internal calibration leak This function starts the check of the
internal calibration leak.
Select "Standby > Calibration > Check
internal calibration leak"
Reassessing background You can use the background
reassessment to start a start/stop cycle to
break
Select "Standby > Calibration >
Reassess background"
6.3 Basic settings
You are able to save the actual settings of the device at any time, so that you can use
them at a later time, see also "Loading/saving parameters [}43]".
6.3.1 Global settings
For an overview of the setting options, please note the menu tree display. You can
carry out your own settings or keep the factory settings.
If necessary, you can save your settings at any time to restore an earlier condition.
You reach the menus via
Standby > Configuration > Global settings
• Display
• Access control
• Maintenance & service
• Interfaces
To Next Page
Loading...