Operating manual and inspection booklet
Camping
154 3435216
I
6.3.4.1 Applicable if the TRUMA combination heater is installed
1. Close the combined drain valve at the freshwater tank.
2. Close valves for cold and hot water pipes, see safety drain
valve.
3. Fill fresh water tank.
4. Fill the boiler. Turn the mixer lever of the mixer tap in
direction of the hot water setting (red mark) and pull upward.
Cold water is pumped from the fresh water tank into the
boiler.
5. Close the mixer lever after all air has been expelled from the
water pipe and cold water flows.
6. Start the heater.
Hot water will be available after approximately 30 minutes.
Fig. 158: Safety drain valve open
Fig. 159: Safety drain valve closed
Open drain valve manually:
To the top rotary switch (1) until it engages. A push-
button (2), which is located at the bottom of the housing, will
pop out ( observe applicable operating instructions).
Close safety drain valve:
When closing the valve, the push-button must be pressed and
the rotary knob must be turned simultaneously 90 degrees.
The push-button must remain in this position; otherwise, the
valve will remain open.
To Next Page
Loading...