Operating manual and inspection booklet
Technical data
3435216 43
NOTE
Further information on correct loading can be found
the following chapters
“Technically permissible mass”
“Technically permissible mass on the axle (mass
on the axle)”
“Load distribution and load securing”
3.3 Built-in devices
The technical data of the built-in devices are provided in the
respective operating manuals. These are in the document case.
Depending on the selected fittings, they include the
documentation for:
Kitchen appliances (e.g. refrigerator, oven, grill)
Heater, boiler, sanitary system
Electric control, storage battery, charger
Optional equipment (e.g. grill)
3.4 Fuses and fuse plug-ins
230 V and 12 V are available in the motorhome. Both circuits have
their own fuse system.
3.4.1 230 V input and main fuse
Power connection
Fig. 2: Electrical connections
The connection to the 230 V power supply can be found outside
the vehicle along the side wall.
The 3-pole CEE plug installed permanently in the motor home is
used as connection.
Before travelling to foreign countries, obtain
information about the plug and connector systems
used at your destination. Suitable adapters are
commercially available.
To Next Page
Loading...