Operating manual and inspection booklet
Camping
3435216 125
6.1.7 Replacing the gas bottle (DuoControl CS) (optional)
In Control CS (with Eis-Ex and remote display)comply with the
following instructions:
WARNING
Danger of explosion and injury due to gas!
Escaping gas can cause poisoning and explosions.
• All repairs on the gas system must be performed
only by authorised specialist personnel.
• If gas odour is detected:
– Immediately shut down the gas supply.
– Do not operate any electric devices.
– Remove fire and sources of ignitions.
– Do not smoke.
– Have gas system repaired immediately.
Fig. 107: DuoControl CS gas supply
1. Open the gas bottle box.
2. Close the bottle valve of the empty gas bottle.
3. Manually unscrew the union nut of the high-pressure hose
at the gas bottle valve (note left-handed thread).
4. Loosen the fastening belt of the empty gas bottle and
remove the empty bottle from the gas bottle box.
5. Place the new gas bottle in the gas bottle box and secure
with the fastening belt.
Gas leak if the gasket is damaged!
If the high-pressure hose is overtightened, the gasket
may become crushed, causing a leak.
• Use only the supplied tool to attach and detach the
high-pressure hoses! It ensures the correct
tightening torque and prevents damages to the
screw joints.
To Next Page
Loading...