Operating manual and inspection booklet
Overview
74 3435216
Care tips
Thoroughly vent the roof bellows several times during
the season, to prevent stagnant moisture and musty
smells.
Do not fold the pop-up roof in damp or wet condition
immediately after rainfall, for example.
Prior to longer periods between use, remove the bed
pad from the pop-up roof to avoid stagnant moisture
and mildew.
Also observe the care tips in section 7.3 on page 183!
5.1.10 Light in the entrance area
Fig. 42: Multifunction switch (example)
One or two switches are installed at convenient height in the
entrance area. They control the various sources of light from
inside and outside of the vehicle, permitting lighting the interior
before entering the vehicle body.
5.1.11 Exhibition lighting (optional)
The vehicle is equipped with the light function referred to as
“Exhibition lighting”.
By pressing the button for the awning lighting 5 times in the
entrance area, the exhibition lighting system is activated. This
means that the base light (awning light, ceiling light, kitchen light,
bathroom light) and the indirect lighting will automatically switch
on again no later than 30 seconds after it has been switched off.
If it has been activated accidentally, it can be cancelled by
pressing the awning lighting button 5 times again.
To Next Page
Loading...