Operating manual and inspection booklet
Camping
158 3435216
Fig. 164: Example of a table in its lowered
position
Putting down the cushion
The illustration on the left-hand side shows a lowered table with
cushions partially in place. In order to utilise the entire area as a
bed, any additional cushions from the vehicle, e.g., the backrests
of the seats, must be placed onto the table top.
6.4.3 How to set up a berth
Fig. 165: Single beds
Fig. 166: End-to-end sleeping area
Depending on the selected features, there are foldable beds in
the sleeping area and additional storage space underneath or
two single beds.
To turn this level into an end-to-end sleeping area, a sliding
panel must be installed across the aisle between the beds
and additional cushions must put in place.
Depending on the floor plan of the vehicle, instead of two single
beds a double bed can be installed lengthwise or crosswise, or a
bunk bed can be integrated.
To Next Page
Loading...