Operating Manual
- Page 76 -
7.2.6.5 Lock or Unlock Program
Lock or Unlock Program allows the user to protect a program from editing. If the program is locked,
the user will not be able to change any of the program data. Unlocking the program will allow the
data to be changed again.
7.2.6.6 Password Setup
Password Setup allows the password to be set or reset for the current program.
To set the password, select F2 MENU (F2 KEY), Utility Menu, and Password Setup. The user will
be prompted for a NEW PASSWORD. Type the new password and press ENTER.
If the password is left blank and ENTER is pressed, the password will be removed. After changing
or resetting the password, the robot power should be turned off.
The purpose of the password is to protect the program from unauthorized editing. The user will not
be allowed to enter TEACH mode unless the correct password is entered. If the password is
forgotten, the master password (777) can be used to gain access to the program.
7.2.6.7 Key Beep
To set the “beep” sound on or off when pressing the key on teach pendant.
7.2.6.8 Test Function
To test the Robot Sensor, Panel Connector, Input Output signal, Teach Pendant and Motor.
7.2.6.9 Clear Teach Pendant Data
To erase all data stored inside the teach pendant.
To Next Page