Operating Manual
- Page 9 -
2.1 Unpacking the Robot
• Always lift the robot from its base. Never lift the robot from the cross member.
• Remove all accessories from the shipping package before attempting to remove the robot.
• Place the robot on a stable workbench before operating
If you can, do not discard the packing material as these items may be needed if the robot is shipped
or moved in the future.
2.2 Setup
• Remove the shipping bracket by removing the screws that secure it. Keep the shipping
bracket and screws in a safe place for future use.
• Connect one end of the Teach Pendant cable to the Teach Pendant and the other end to the
Teach Pendant connection on the robot.
• Connect the power cord of the robot to the power socket on the robot. Be sure to use the
correct power cord and power source for the robot model you are using (220 V).
• Tie back all cables and air lines so that they will not interfere with the robot’s motion when
the robot is operating. Be sure that the cables and air lines do not restrict the motion of the
robot’s head and the robot’s table and make sure that they cannot become jammed as the
robot moves through the work area.