Loctite EQ RB20 500D - Double Table Run Mode

Operating Manual
- Page 97 -
Instruction Display Shows
Select needle calibration mode. Then press
ENTER.
I.E. To set calibration mode to Fast, press 1 then
press ENTER.
[Needle Adjustment Setup]
-----------------------------
Loop:3
1.Fast (now)
2.Precise
Select:1
7.4.26 Double Table Run Mode
Instruction Display Shows
F4 Menu Page 4 Double Table Run Mode
[Double Table Run Mode]
-----------------------------
1. Normal
2. Cycle
Select:
-----------------------------
Press numbers to set Run Mode for dual table.
Then press ENTER.
I.E. To set to Normal mode
[Double Table Run Setup]
-----------------------------
1. Normal
2. Cycle
Select:1