Operating Manual
- Page 63 -
7.1.27 Double Table Switch
Instruction Display Shows
1
Press the F1 key, then to select Double Table Switch
Double Table Switch Setup
------------------------------------
1:Left Table
2:Right Table
Select:
2
Type 1 then press ENTER to select left table.
Or type 2 then press ENTER to right table.
Double Table Switch Setup
------------------------------------
1:Left Table
2:Right Table
Select:1
7.2 F2 Menu (F2 Key)
7.2.1 Group Edit
Group Edit is a powerful utility, which allows several different functions to be applied to a user-
defined group of addresses. These functions include copy, delete, move, multiply line speed,
multiply dispense times, apply X Offset, apply Y Offset, and apply Z Offset.
7.2.1.1 Copy
For example, to use group edit to copy addresses 1 – 10 in the current program to memory address
11 - 20:–
Instruction Display Shows
1
Press the F2 key, then 1 to select Group Edit.
The display will prompt the user to enter the starting
memory address of the group to edit (From) and the
ending number of the group to edit (To).
GROUP EDIT
FROM: 1
TO: 1
(1 <-> 4000)
w+: All w-: End
To Next Page
