Loewe Connect ID 46 - Troubleshooting Guide; Resolving Common TV and Connection Issues

Connect ID 32-46 - 136 -
Operating instructions
Problem Possible cause Remedy / hints
The TV set switches off automatically. The automatic shutdown switches off the TV
set to save energy after 4 hours of inactivity
as soon as at least one signal input group is
set up in the energy efficient mode Home
Mode.
Using automatic shutdown is recommended for
the purposes of energy saving and safety.
All menus are displayed in the wrong
language.
The menu language was set incorrectly. Set the menu language:
Press the MEDIA button in TV mode. In the
MediaPortal, highlight the last menu item
(Index) in the upper half and call up with OK.
Mark the first key word and call it with OK.
Then select the language and confirm it with
OK.
In the TV menu, Connections cannot be called
(displayed in grey).
A timer recording is in progress. Wait until the timer recording ends or delete
the timer recording (page 127).
The control functions of the Loewe Recorder
and the Timer are not working or are not
working properly
a) The Digital Link function is not activated or
not possible in the recorder.
b) EURO-AV cable is not connected.
a) Activate Digital Link in the recorder (see
operating instructions of the recorder).
b) Connect EURO-AV cable (page 115).
General problems when connecting external
devices via an AV input.
a) The AV standard is set incorrectly.
b) The signal type is set incorrectly.
a) Set the correct standard (page 112).
b) Set the correct signal type (page 112).
If AV standard or AV signal is set to “Automatic”
then this can cause errors to be detected with
signals that do not comply with standards. In
this case standard and signal must be set
according to the information in the operating
manual of the external device.
The connection of a decoder does not
function or does not function properly.
a) The signal is not decoded because the cor-
rect decoder stations are not selected in the
menu.
b) The sound is missing in decoder mode be-
cause the wrong decoder sound is assigned
in the menu.
a) Select the right decoder stations in the menu
(TV menu ט Connections ט Miscellaneous ט
Decoder stations טSelect decoder station(s)
(see page 113).
b) Select the right sound code (always, never,
automatic) in the menu (TV menu ט
Connections
ט Miscellaneous ט Decoder
stations טSound encodig), see also decoder
instructions.
Digital Link Plus does not work. a) EURO-AV cable is not fully wired (pin 10
not wired).
b) Some recorders can only adopt stations
during the initial installation of the TV set.
a) Replace the EURO-AV cable.
b) Restore the recorder to the as-delivered
state (see recorder’s operating manual).
With Teletext various characters are displayed
incorrectly.
The wrong character set has been set in the
Teletext menu.
Set the right character set: Select Teletext
menu ט Settings ט Character set ט Standard
or the appropriate character set.

Troubleshooting