Appendix D
9-11
This screen will appear as the downloading takes place.
LOOP V4200-9 === Download Firmware === 16:27:32 08/18/2003
ARROW KEYS: CURSOR MOVE, BACKSPACE to edit, ESC to abort
Current Software Ver.: V3.07 01/01/2003
Current Firmware Bank: 1
NextBootFirmware Bank: 1
TFTP Server IP : 192.168.100.206
Firmware File Name : l4200v38.run
16:25:01 08/18/03 Downloading Firmware ...Reveived 188 Blocks
<< Press ESC key to abort, ENTER key to continue >>
If the specified firmware is downloaded successfully, the words “check sum ok” will appear
on your screen. For demonstration purpose, those words are highlighted on the sample
screen below. Press ESC
LOOP V4200-9 === Download Firmware === 16:27:32 08/18/2003
ARROW KEYS: CURSOR MOVE, BACKSPACE to edit, ESC to abort
Current Software Ver.: V3.07 01/01/2003
Current Firmware Bank: 1
NextBootFirmware Bank: 1
TFTP Server IP : 192.168.100.206
Firmware File Name : l4200v38.run
16:25:01 08/18/03 Downloading Firmware ...Reveived 1536 Blocks
16:28:45 08/18/03 Received 786432 bytes in 225 seconds
16:28:56 08/18/03 check sum ok
16:28:56 08/18/03 Download Success
<< Press ESC key to continue >>
NOTE:
When new firmware is downloaded to a Loop-V 4200-9 that has its current firmware in BANK 1, the
new firmware is not activated until the Loop-V 4200-9 is rebooted. Upon reboot the newly
downloaded firmware will automatically be switched to BANK 2 and it will become the new current
firmware, Similarly, if the current firmware is in BANK 2, the newly downloaded firmware will be
switched to BANK 1 upon rebooting. BANKS only switch after a download occurs and the Loop-V
4200-9 is rebooted.
After the downloading is successfully completed and a reboot takes place, the newly downloaded firmware
will be called the current firmware. The previous firmware will be stored in the other BANK for backup. If a
download fails and the user wishes to revert to the previous firmware, instructions for doing so can be found
in Section 9.2 of this appendix.
To Next Page
Loading...