Appendix D
9-9
Key in ‘ping’ and the IP address of the Loop-V 4200-9 as shown on the sample screen below. (If you will be
downloading via the Router Card use the IP address of the Router Card Ethernet Port). Then press ENTER.
The ping test results will appear on the screen.
If the ping test is successful close the MS DOS prompt window. If the test is unsuccessful, check all
connections and check that you have entered all IP addresses properly and that they are in the right domain.
Maximize the Loopterm window. It should still display the Controller Menu. Press “L” from the
Controller Menu to access the Download/Upload Firmware screen.
LOOP V4200-9 ===Download/Upload Firmware === 16:25:51 08/18/2003
>> Select ? *DOWNLOAD UPLOAD
To Next Page
Loading...