24
Motion Detection
With the Screen Saver activated, motion detection is enabled on the system. When motion is
detected by one of the cameras, the LCD receiver will display the triggered camera in single-
channel full-screen, and the motion alarm will beep, but the system will not record. When the
motion trigger is finished, the system will return to Screen Saver mode.
NOTE: Unless the REC stamp appears on-screen, the system is NOT recording.
Screen Saver with Motion Recording
You can also enable Motion Recording to function with the Screen Saver.
To enable Screen Saver with Motion Recording:
1. From live viewing, press the Motion button. “AUTO REC” appears on the LCD receiver.
2. Press the Scan/Del button to enable the Screen Saver. “SCAN” appears on the LCD receiver.
When motion is detected by one of the cameras, the system will display the triggered camera
on-screen, the alarm will beep, and the system will record.
When motion recording is finished, the system will return to Screen Saver mode.
NOTE: You can set the length of motion recording from the Record Menu. For details, see
“Record” on page 39.
SCAN
SD
C
C
a
a
m
m
1
1
Figure 5.5 The Screen Saver displays the triggered camera when motion is detected.
SCAN
SD
C
C
a
a
m
m
1
1
R
R
E
E
C
C
160602-1.AVI
Figure 5.6 Set Motion Recording along with the Screen Saver
To Next Page
Loading...
Need help?
General
