Lorex LW2700 SERIES - Manual Recording; Performing Manual Recording

27
Manual Recording
Manual Recording allows you to manually start/stop recording from one channel at a time . You
cannot record while in Quad mode.
You can also record while in Zoom mode. For details on using Zoom, see “Zoom” on page 52.
NOTE: You cannot change channels or enable Auto Sequence Viewing Mode during Manual
Recording.
To enable Manual Recording:
1. Select a channel (1~4) on the wireless receiver or from the remote control.
2. Press the Record—
button.
3. To stop Manual Recording, press the Record—
button again. “NEW” will appear on the LCD
receiver indicating a new file is on the SD card.
When Should I Use Manual Recording?
• Emergency recording
•
Low traffic environments
Fi
g
ure 7.0 Recordin
g
indicated by the OSD
C
C
a
a
m
m
1
1
R
R
E
E
C
C
160602-1.AVI
2009 07 17
16:32:05