62
Appendix G: Power Failure
A power failure may interrupt recording modes on the system. After power is restored, the
following will occur:
• The system will restart in Auto Sequence Mode + Motion Recording – this ensures that
some form of recording will be immediately active on the system
NOTE: If you had a different display view or recording mode set when the power failure occurred,
you will need to re-apply the previous display view and recording mode.
A flashing Power Failure icon will appear on-screen – the Power Failure icon indicates
that a power failure occurred while the system was
actively recording
(i.e. “REC” icon
was on-screen)
NOTE: The flashing icon appears
only
if the system was actively recording when the power failure
occurred. The flashing icon will disappear when you press buttons on the receiver or remote
control.
C
C
a
a
m
m
1
1
R
R
E
E
C
C
160602-1.AVI
2009 07 17
16:32:05
Figure 16.0 Power Failure icon
Power Failure
icon
To Next Page
Loading...
