Lorex LW2700 SERIES User Manual

31
The “REC” indicator will only appear when motion is detected by one of the cameras on-screen.
By default, the system is set to record for 15 seconds after the triggered motion event. For
details on adjusting the motion recording time, see “Trigger Record” on page 41.
When Should I Use Motion Recording?
• Low traffic areas or non-sensitive/non-critical recording environments
•
Overnight recording
NOTE: In the event of a power failure, the system will restart in Auto Sequence Mode + Motion
Recording when power is restored. For more details, see “Appendix G: Power Failure” on page 62.
Recording Tip!
If you are using more than one camera , it is highly recommended to use Quad Mode with Motion
Recording
. Quad Mode allows you to see all four cameras at once. When motion is detected, the
triggered camera will appear on-screen. After motion recording is complete, the receiver will
return to Quad Mode.
System in Quad Mode
with Motion Recordin
g
Camera 2 detects motion, so the
system starts recording and
camera 2 is displayed on-
screen
C
C
a
a
m
m
2
2
R
R
E
E
C
C
160602-2.AVI
2009 07 17
16:32:05
SD
Once motion recording is
finished, the system
returns to Quad Mode

Lorex LW2700 SERIES Specifications

General

Brand	Lorex
Model	LW2700 SERIES
Category	Security System
Language	English