Smart Motion Detection14
6. Click Set next to Area to set active areas for person and/or vehicle detection.
• Click Add to set an area for person or vehicle detection on the selected channel. Click-
and-drag the corners to resize the area.
• For most accurate results, set an area where objects of interest will move within the
bounding box as well as into / out of.
• Check Light next to a rule to flash the camera’s warning light when an object is detected.
• See 14.1 Ensuring Accurate Person & Vehicle Detection, page 43 for optimal camera po-
sitioning for person and vehicle detection.
7. Click Set next to Schedule to set a weekly schedule for person and/or vehicle detection.
• Click or click-and-drag along each of the yellow timelines to quickly add or remove time
from each day’s schedule in 15–minute segments.
• Click
beside 2 or more days to link schedules ( ). This allows you to quickly
change multiple schedules at once.
• To make fine adjustments to a schedule, click Set. This will allow you to set exact start
and end times for a schedule.
• Click OK when finished.
8. If you choose to flash the camera’s warning light when a person or vehicle is detected, con-
figure the following warning light options:
• Duration: Enter the time in seconds the warning light will remain on after a person or ve-
hicle is detected.
• Warning Light / Strobe: Choose Warning Light to use a solid white light, or Strobe
for a flashing light. If you select Strobe, choose the Strobe Frequency to determine how
quickly the warning light will flash when triggered.
#LX400117; r. 6.0/57895/57895; en-US 45
To Next Page
Loading...
Need help?
General