Using the Main Menu16
2. Click , then click NETWORK. Click the Switch Settings tab on the side panel.
3. Configure the IP Address, Subnet Mask, and Default Gateway for the internal PoE switch.
4. Click OK. Click Save to save changes. The system will restart.
16.4.7 P2P Setting
The P2P Setting menu is used only to enable / disable remote access to the system using a P2P
connection.
CAUTION
P2P connection is the primary method used for remote access to your security system using the app. If you dis-
able P2P connectivity, you will only be able to access your system over the Internet using DDNS. See 22 DDNS
Setup (Advanced), page 101 for details.
To change P2P setting:
1. From the Live View display, right-click to open the Quick Menu, then click Main Menu.
2. Click
, then click NETWORK. Click the P2P tab on the side panel.
#LX400117; r. 6.0/57895/57895; en-US 72
To Next Page
Loading...
Need help?
General