Operation control
Operation control 2-
9
Note:
* Be sure to stop the engine while refueling.
* Never go near a fire.
▶ If you are negligent ……
It could cause a fire.
IMPORTANT
Do not carry out routine inspection only through simple detection device, but carry o ut actual inspection.
(Refer to the "schedule of routine inspections" section.)
3. Horn switch
When the starting key is in the "ON" position, press the horn switch an d the horn will beep.
4. Operating light switch
When the starting key is in the "ON" p osition, put the operating light switch in the "ON" position and the
operating light will be ON. The driver's seat of this machine is a seat with front and rear sliding rails.
Horn switch
Start Switch
The simple instrument
The light
switch
To Next Page
Loading...