Inspection, Maintenance and Adjustment
Check, maintain and adjust 4-
10
Maintain of every 50 hours
Drainage of fuel tank
1. Fuel tank
Remove drain plug from bottom of fuel tank from
bottom of swivel rack.
2. Water-oil separator
If there is water in the oil cup, the red float will float.
At this time, please put the handle of the oil and
water separator in the position of "CLOSE", loosen
the fixing ring of the oil cup, remove the oil cup, and
pour out the water in the oil cup.
IMPORTANT
Please be careful not to get dust or dust when
assembling.
Exhaust the water in the oil cup. (Please refer to
"Exhaust of fuel system" section)
Grease injection on the tooth root surface of
rotary bearing
1. Please inject grease from grease gun nozzle
marked with arrow.
2. Please turn it once every 90 degrees and add
grease in 4 times.
3. When filling grease, inject about 50g (grease gun
about 20 times) grease into each place t h rough
the nozzle of grease gun, and add grease t o the
whole tooth root surface.
Drain plug
Grease gun nozzle
Oil-water separator handle
lines
Float (red)
Oil cu
Fixed a cup
To Next Page
Loading...