Operation
Operation 3-
14
Engine stop
1. The key of parking
Warning
* When the engine is s topped, do not leave t he
working device and shovel in the suspended state.
Otherwise, the device will slowly fall down due to
its weight, resulting in an a ccident.
Push the throttle h andle to the bottom of th e slow speed and allow the engine to idle for about 5 minutes,
allowing it to cool down slowly.
Slowly operate the left and right operating handles and place the operating device on the ground.
Place the startin g key in the "STOP" position, STOP the engine, and remove the k ey.
Pull up the handle lock le ver and place it in t he "lock" position.
IMPORTANT
The bucket should touch the ground before stopping the engine. The dead weight of the working device
cannot be relied u pon to make contact with the ground.
With the throttle handle in a high speed position, t he engine sometimes cannot stop. At this point, be sure
to place the throttle handle at a low speed and turn the key to the "STOP" position.
2. Emergency engine stop with a fuse
Note:
* Do not open the engine cover until the engine
stops. Only in case the engine cannot be stopped,
open the hood and pull out the fuse to stop the
engine.
Remove the cover of the fuse box and remove the internal fuse. The engine will stop. Put the fuse back in
place and the engine will start ag ain.
IMPORTANT
When the engine cannot stop using the key, please contact the dealer.
Pull out
Open
the
Engine emergency
Out of service fuse
To Next Page
Loading...