LPKF ProtoMat E34 - Page 10

Contents
ProtoMat E34/E44
10/78
LPKF Laser & Electronics AG | V. 1.0
6.4 Special tasks ................................................................................................60
7 Maintenance ........................................................................................................67
7.1 Safety ...........................................................................................................67
7.2 Maintenance schedule .................................................................................67
7.3 Maintenance tasks for the maintenance personnel of the operator ............68
8 Troubleshooting .................................................................................................70
8.1 Fault display .................................................................................................70
8.2 Actions in case of an error ...........................................................................72
8.3 Fault table ....................................................................................................72
9 Disassembly and disposal .................................................................................74
9.1 Safety ...........................................................................................................74
9.2 Preparations .................................................................................................74
9.3 Uninstalling the system ................................................................................74
9.4 Disposing of the system ...............................................................................75
10 Appendix .............................................................................................................76
10.1 List of figures ................................................................................................76
10.2 List of tables .................................................................................................77
10.3 EC Declaration of conformity .......................................................................78
This document describes two systems that resemble each other. ProtoMat E34 and
ProtoMat E44 are identically constructed, differing only in a few characteristics. The
following always describes the system. For comprehensibility and practicability of the
instruction steps, it does not matter which of the two systems is described. The
characteristics that serve for differentiation are marked clearly in this document.