LPKF Laser & Electronics AG | V. 1.0
1.2 Residual risks
No residual risks have currently been identified, if the intended use as well as all
safety regulations are observed. Non-observance can cause personal injuries and
property damage.
1.3 Basic hazards
Always comply with the warning messages listed here and in the individual sections of
this documentation to reduce the risks of injuries and property damage and to avoid
dangerous situations.
Mechanical hazards
Risk of injury by moving components!
Moving components can cause serious injuries e.g. crushing injuries or cuts.
Never grasp moving components when the system is operating.
Observe the follow-up time of the spindle. Before doing any work in the
processing area or on the processing head, ensure that no component is still
moving.
Tripping hazard by hoses and cables!
Hoses and cables are routed to the system. If the hoses and cables are laid
inappropriately they pose a tripping hazard for the operating personnel.
Always ensure that the hoses and cables do not pose a tripping hazard.
Electrical hazards
Danger to life by electrical shock!
Touching energized parts causes a direct danger to life by electrical shock. Damage
to the insulation or damaged individual parts can be dangerous to life.
All work on energized components of the system must be performed by a
qualified electrician.
If the insulation is damaged, switch off the power supply immediately and initiate
the repair.
De-energize all energized components of the system or equipment, before
working with them. Ensure that the system or equipment is de-energized for the
whole time of the task.
Never bridge or deactivate fuses.
Always keep moisture away from energized parts because it can cause a short
circuit.
To Next Page
Loading...