V. 1.0 | LPKF Laser & Electronics AG
4 Transport and storage
This chapter contains important information on transport, packaging and storage of the
system.
System damage by improper transport!
Improper transport can cause damage to the system.
Transport the system cautiously to the place of installation.
Observe the symbols on the packages.
Remove the packaging only directly before system installation.
4.1 Transport inspection
Check the delivered goods immediately upon receipt for completeness and for
transport damage.
If transport damage is evident, proceed as follows:
Do not accept the delivery or only with reservations.
Record the extent of damage on the transport documentation or on the delivery
note of the transport company.
Initiate a complaint.
4.2 Transport
Preparing the system for transport
1. Switch off the system before transport.
2. Disconnect all connections of the system (for an overview of the connections refer
to page 26).
In case of the ProtoMat E44, the camera connections have to be disconnected
additionally.
3. Insert a tool or the dummy tool if no tool is in the collet.
4. Install the transport lock beneath the processing head.
5. For transport over longer distances, pack the system in its original packaging.
For transport over short distances, the transport lock does not have to be installed
and the system does not have to be packed.
The system has been prepared for transport.
Follow the unpacking instructions attached to the packaging.
To Next Page
Loading...