LPKF ProtoMat E34 - 10 Appendix; 10.1 List of Figures

Appendix
ProtoMat E34/E44
76/78
LPKF Laser & Electronics AG | V. 1.0
10 Appendix
This chapter contains navigation elements of the document.
10.1 List of figures
Fig. 1: Type label ....................................................................................................22
Fig. 2: System overview .........................................................................................23
Fig. 3: Processing head ..........................................................................................24
Fig. 4: Processing table ..........................................................................................24
Fig. 5: Vision system ..............................................................................................25
Fig. 6: Connections .................................................................................................26
Fig. 7: Displays and control elements ....................................................................28
Fig. 8: Equipment configuration wizard ..................................................................29
Fig. 9: Minimum required space .............................................................................35
Fig. 10: Workplace of the operating personnel ........................................................36
Fig. 11: Connecting the system ................................................................................37
Fig. 12: Connecting the extraction system ...............................................................38
Fig. 13: D-sub connector of the ProtoMat E34/E44 .................................................38
Fig. 14: D-sub connector of the extraction system ...................................................38
Fig. 15: USB socket ..................................................................................................39
Fig. 16: Power supply socket ...................................................................................39
Fig. 17: Pulling the processing head to the front ......................................................40
Fig. 18: Plugging the insertion tool onto the dummy tool .........................................40
Fig. 19: Loosening the locking screw .......................................................................41
Fig. 20: Extracting the dummy tool ...........................................................................41
Fig. 21: Dummy tool .................................................................................................41
Fig. 22: Dialog New document .................................................................................44
Fig. 23: User interface CircuitPro PM .......................................................................45
Fig. 24: Selecting the machine type .........................................................................45
Fig. 25: Connection steps .........................................................................................46
Fig. 26: Importing the data........................................................................................47
Fig. 27: CAM view with opened project ....................................................................47
Fig. 28: Create fiducial ..............................................................................................48
Fig. 29: Four fiducials ...............................................................................................48
Fig. 30: Technology Dialog .......................................................................................49
Fig. 31: Computation results ....................................................................................50
Fig. 32: Create rectangle to create a rubout area ....................................................51
Fig. 33: Rectangle surrounding the IC pads .............................................................51
Fig. 34: Processing table ..........................................................................................53
Fig. 35: Processing table with drilling underlay plate ...............................................53
Fig. 36: Fastening the material .................................................................................54
Fig. 37: Operate ........................................................................................................54
Fig. 38: Material settings ..........................................................................................55
Fig. 39: Defining the right rear corner .......................................................................55
Fig. 40: Defining the front left corner ........................................................................56
Fig. 41: Placement ....................................................................................................56
Fig. 42: Alignment .....................................................................................................58
Fig. 43: Micrometer screw at the processing head ..................................................60
Fig. 44: Optimum milling depth .................................................................................60
Fig. 45: Inserting a screwdriver ................................................................................61
Fig. 46: Removing the reference-hole strip ..............................................................61
Fig. 47: Reference-hole strip ....................................................................................61
Fig. 48: Inserting the reference-hole strip .................................................................62
Fig. 49: Dialog Drill reference holes .........................................................................62
Fig. 50: Reference-hole drill .....................................................................................62
Fig. 51: Prompt for cleaning the tool ........................................................................63