LPKF Laser & Electronics AG | V. 1.0
9 Disassembly and disposal
This chapter describes the disassembly and the disposal of the system.
The following tasks may only be performed by the maintenance personnel of the
operator.
9.1 Safety
Environmental hazard by improper disposal of the system!
Improper disposal of the system can cause hazards to the environment.
Dispose of the system properly or contact the LPKF Service.
9.2 Preparations
Before disassembling the system:
Switch off the system.
Disconnect all external components and de-energize the residual energy.
Remove all operating materials, auxiliary materials, and consumables and dispose
them of in an ecological way.
9.3 Uninstalling the system
The system is disassembled as follows:
Uninstalling the system
1. Disconnect the mains plug from the wall socket.
2. Disconnect the hose of the extraction system.
3. Disconnect the control cable of the extraction system.
4. Disconnect the USB cable connecting with the PC.
5. Disconnect power supply cable.
6. Install the foam pad as a transport lock beneath the processing head.
The system has been uninstalled.
The PC and the extraction system can now be used for other purposes or can be
stored as well. For information on uninstalling these systems refer to the
corresponding user manuals.
To Next Page
Loading...