LPKF Laser & Electronics AG | V. 1.0
Removing the transport lock
1. Remove the foam pad beneath the processing head.
2. Store the foam pad in the box for a possible transport of the system.
The transport lock has been removed.
4.3 Storage
Store the system in its original packaging according to the symbols on the
packaging.
Store the packages under the following conditions:
Do not store outdoors.
Store dry and dust-free.
Do not expose to aggressive substances.
Protect against sunlight.
Storage temperature: 15 °C - 35 °C (59 °F - 95 °F)
Relative air humidity: 60 % max, non-condensing.
If storing for more than 3 months, check the general condition of all components
and the packaging on a regular basis.
When putting the system out of operation and into storage over a longer period,
ensure that the storage room is clean, almost dust-free, and has a sufficient
loadbearing capacity.
4.4 Packaging
The packaging is chosen according to the transport conditions.
The packaging is to protect the system from transport damage, corrosion, and other
kinds of damage until installation.
Keep the packaging in its original form.
Only remove the packaging just before installation.
4.4.1 Handling packaging material
Dispose of the packaging material according to the current laws and local
regulations.
Environmental hazard by wrong disposal of packaging!
Wrong disposal of packaging material can cause environmental hazards.
Dispose of the packaging material environmentally friendly.
Observe the local disposal regulations and hire a specialized company for the
disposal, if necessary.
The system may only be shipped in the original packaging of LPKF. Contact the
LPKF Service if you need the packaging.
To Next Page
Loading...