LPKF Laser & Electronics AG | V. 1.0
6.4 Special tasks
This chapter describes rarely used tasks that may facilitate working with your system.
The following steps are performed:
Adjusting the milling depth
1. Affix the material to be processed onto the processing table as describe on page
53.
Fig. 43: Micrometer screw at the processing head
2. Adjust the desired milling depth with the micrometer screw.
3. Mill a test line.
4. Check the result with a measuring microscope.
Fig. 44: Optimum milling depth
5. Repeat the procedure if necessary until sufficient material has been removed.
The milling depth has been adjusted.
To Next Page
Loading...