LPKF Laser & Electronics AG | V. 1.0
6.3.3 Processing the material
This chapter describes how the material is processed based on the prepared data.
This is done by executing the following steps:
Placing and fastening the material on the processing table
Starting processing
Defining the material settings
Placing the layout
Drilling fiducials (E44 only)
Processing the material (Bottom side)
Turning the material over
Searching fiducials (E44 only)
Processing the material (Top side)
Health hazard by gases or dusts!
Processing materials with laser beams can produce gases or dusts hazardous to
health.
Only process materials that are approved by LPKF.
Always ensure that the extraction system is switched on and working properly.
Burn hazard by hot surfaces!
During processing, some system components can heat up so much that direct
contact can cause burns.
Always wear your personal protective equipment.
Risk of injury by sharp edges and points!
Improper handling of the tools used can cause cuts and puncture wounds.
Always use the delivered insertion tool.
Always store the tools in the tool box.
Never touch the processing head during operation.
To Next Page
Loading...