EasyManuals Logo

LSIS S100 Series User Manual

LSIS S100 Series
95 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #9 background imageLoading...
Page #9 background image
Chapter 3. Installation
7
NPN Mode (Sink)
Select NPN using the PNP/NPN selection switch (SW1). Note that the factory default setting is NPN mode. CM
is is the common ground terminal for all analog inputs at the terminal, and P12 is 12V internal source.

Other manuals for LSIS S100 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the LSIS S100 Series and is the answer not in the manual?

LSIS S100 Series Specifications

General IconGeneral
BrandLSIS
ModelS100 Series
CategoryController
LanguageEnglish

Related product manuals