Chapter 6. Panel Editor
6-20
4) PLC type
Designate the type of PLC to connect for each channel (Ch.1: RS-232C, Ch.2: RS-422/485).
Available Devices Description
Not used Not used
LS:MASTER-K(Loader) Select to connect to LS MASTER-K series loader port.
LS:GLOFA-GM(Loader) Select to connect to LS GLOFA series loader port.
LS:MASTER-K(Link) Select to connect to LS MASTER-K series Cnet port.
LS:MASTER-K(Link)
500H 1000H
Select to connect to LS MASTER-K 500H, 1000H series.
LS:MASTER-K(Link)
10S 30S 60S 100S
Select to connect to LS MASTER-K 10/30/60/100S series.
LS:MASTER-K(Link)
10S1
Select to connect to LS MASTER-K 10S1.
LS:GLOFA-GM(Link) Select to connect to LS GLOFA series Cnet port.
LS:Slave(Link) Set the XGT Panel as a slave of LS Cnet.
LS:Inverter Select to connect to the LS inverter.
MODBUS_Master(RTU) Set the XGT Panel as a MODBUS RTU mode master.
MODBUS_Master(ASC) Set the XGT Panel as a MODBUS ASC mode master.
MODBUS_Slave(RTU) Set the XGT Panel as a MODBUS RTU mode slave.
MODBUS_Slave(ASC) Set the XGT Panel as a MODBUS ASC mode slave.
MELSEC FX(LINK) Select to connect to the MITSUBISHI FX series.
OMRON:C-Mode Select to connect to the OMRON PLC through C-Mode.
KOYO_DL06 Select to connect to the KOYO Direct 06.
NAIS:FP_MEWTOCOL Select to connect to the NAIS FP series through MEWTOCOL.
Ch 1
RS-
232C
ST/PS-9000 Select to connect to the ST/PS-9000.
Not used Not used
LS:MASTER-K(Link) Select to connect to LS MASTER-K series Cnet port.
LS:MASTER-K(Link)
500H 1000H
Select to connect to LS MASTER-K 500H, 1000H series.
LS:MASTER-K(Link)
10S 30S 60S 100S
Select to connect to LS MASTER-K 10/30/60/100S series.
LS:MASTER-K(Link)
10S1
Select to connect to LS MASTER-K 10S1.
Ch 2
RS-422
/485
LS:GLOFA-GM(Link) Select to connect to LS GLOFA series Cnet port.
To Next Page
Loading...
