Lucent Technologies Lineage
®
2000 ECS/GPS Battery Plant J85500G-2
2 - List of Figures Issue 6 May 1999
Figure 3-4: Cabling Arrangement 3 - 42
Figure 3-5: Frame Ground Adapter Assembly 3 - 43
Figure 3-6: Typical J-Drawing A-Sheet 3 - 43
Figure 4-1: Typical floor mounting detail 4 - 5
Figure 4-2: Floor mounting template (all dimensions
are given in inches) 4 - 6
Figure 4-3: LVD/fuse board (CP5) jumper locations 4 - 8
Figure 4-4: LVD/fuse board with thermal compensation
circuitry (BMD1) switch locations 4 - 8
Figure 4-5: 216A Battery Thermal Compensation
Control Unit faceplate 4 - 18
Figure 4-6: Door assembly 4 - 19
Figure 4-7: VR Battery stand (placement of thermistors) 4 - 19
Figure 4-8: Plant frame work (placement of control
unit, option 1) 4 - 20
Figure 4-9: Door panel (placement of control unit,
option 2) 4 - 21
Figure 4-10: 216A Battery Thermal Compensation
Control Unit installed on frame 4 - 22
Figure 4-11: Terminal block assembly 4 - 23
To Next Page
Loading...