MERLIN LEGEND Communications System Release 6.1
Maintenance and Troubleshooting
555-661-140
Issue 1
August 1998
Page 3-8
System Requirements for Touch-Tone Receivers
d. Dial
;
wait for silence, and then quickly press the
Recall button to perform a switchhook flash.
You should hear a confirmation tone (three beeps).
e. Hang up.
You should hear a ring burst, and the Message LED should turn on.
f. Dial
to turn off the Message LED and resume normal
operations.
! If these tests fail, replace the MFM.
Table 3–2. MLX Telephone Display Buttons
System Requirements for
Touch-Tone Receivers
A voice messaging system requires a certain number of TTRs in addition to any
system requirements for TTRs. The number of TTRs depends on the number of
ports used by the voice messaging system (see Table 3–3
). TTRs are also
required in private networks using E&M, T1 tie, and tandem tie trunks.
In Release 6.0 and later systems, the use of the Prompt-Based Overflow
setting, which allows callers to request overflow coverage while waiting in a
Button Display
Home
+20(
Menu
0(18
More
025(
Inspct
,163(&7
Each unlabeled display button ',63/$<%87721
nn
; where
nn
is 1–10,
depending on which button you press.