102
Sending and Restoring SysEx Memory
A “System Exclusive” (SysEx) file contains the settings for all 12 of your presets. You can send
out a SysEx file, and then send it back to your Code Series keyboard later to restore those
presets.
To send a SysEx file from your Code Series keyboard to your DAW:
1. On your computer, set your SysEx librarian to record.
2. On your Code Series keyboard, press Edit to enter Edit Mode. The Edit button will light up.
3. On your computer, start recording with the SysEx librarian.
4. On your Code Series keyboard, press the Mem Dump key. It will ask you what preset you
woulud like to send TO. Use the numeric keys (0–9) or Preset Down/Up () buttons to
enter the desired preset number (00–12), and then press Enter.
5. Your Code Series keyboard will send the SysEx file, and SYS will appear in the display.
To send a SysEx file to your Code Series keyboard from your DAW:
1. On your computer, open your SysEx librarian, and make sure your Code 61 is selected as
the MIDI Out port.
2. Use your SysEx librarian to send a SysEx file.
3. SYS will appear in your Code Series keyboard’s display to indicate that it is receiving the
SysEx file. This will overwrite its current presets.
4. Do one of the following:
• Press one of the Preset Down/Up () buttons to load a new preset.
• Use your Code Series keyboard’s Power Button to power it off and then on again.
Restoring Default Settings
To return your Code Series keyboard to its default settings, press and hold both Pad
Octave –/+ buttons while powering it on. This will overwrite its current presets. The available
default presets are described in Appendix > Presets.
To Next Page
Loading...
Need help?
General
