39
Memory Dump
Press this key to send a “System Exclusive” (SysEx) memory dump for all 12 presets. You can
later send the SysEx file back to your Code Series keyboard to restore your presets.
See Presets and Memory > Sending and Restoring SysEx Memory to learn more.
Data 1
Press this key to enter the Data 1 number (using the numeric keys (0–9)). This number
determines how the control functions (whether a button acts as a momentary or toggle button,
for example). The available numbers and their corresponding functions are listed in Appendix
> Parameter Numbers.
This applies only to a button, a pad, or the sustain pedal when its Control Assign number is
a non-registered parameter number (NRPN, a parameter number higher than 127).
Data 2
Press this key to enter the Data 2 number (using the numeric keys (0–9) or the Preset
Down/Up () buttons). This number determines the control’s minimum value, its “released”
message, etc. The available numbers and their corresponding functions are listed in Appendix
> Parameter Numbers.
Data 3 / +/–
Press this key to enter the Data 3 number (using the numeric keys (0–9) or the Preset
Down/Up () buttons). This number determines the control’s maximum value, its “pressed”
message, etc. The available numbers and their corresponding functions are listed in Appendix
> Parameter Numbers.
MIDI Out / Color
Press this key to enable or disable the MIDI Out port. By default, this port is disabled, but you
can enable it to send out MIDI messages from your Code Series keyboard. It will not send out
incoming MIDI messages from your DAW or the MIDI In port. See MIDI Out to learn more
about this.
Press and hold Shift and then press this key to set the color of the pads or buttons. See
Pads > Editing Assignments > Colors and Buttons > Editing Assignments > Colors to
learn more about this.
To Next Page
Loading...
Need help?
General
