50
MIDI CC Value Cycle
You can set a button to cycle through or switch between 2, 3, or 4 MIDI CC values by each
time you press it.
To assign a button to cycle through or switch between 2, 3, or 4 MIDI CC values:
1. Press Edit to enter Edit Mode. The Edit button will light up.
2. Press the desired button. The button’s number will appear in the display.
3. Press the Ctrl Assign key. The display will show ASGN for 1 second and then show the
button’s number (B__) and a number for the type of message it sends.
4. Use the numeric keys (0–9) or Preset Down/Up () buttons to enter 146.
5. Press the Data 1 key. The display will show DATA1 for 1 second and then show the
button’s number (B__) and the desired MIDI CC.
6. Use the numeric keys (0–9) or Preset Down/Up () buttons to enter a value (000–127).
7. Press the Data 2 key. The display will show DATA2 for 1 second and then show the
button’s number (B__) and the lowest value it will send.
8. Use the numeric keys (0–9) or Preset Down/Up () buttons to enter a value (
000–127).
9. Press the Data 3 key. The display will show DATA3 for 1 second and then show the
button’s number (B__) and the highest value it will send.
10. Use the numeric keys (0–9) or Preset Down/Up () buttons to enter a value (000–127).
11. Press and hold Shift, and then press the Data 3 / –/+ key. The display will show DATA+1
for 1 second and then show the button’s number (B__) an additional value it will send.
12. Use the numeric keys (0–9) or Preset Down/Up () buttons to enter a value between
the lowest and highest values (000–127).
13. Optional: To set one more value the button will send, repeat Steps 11–12 once more, but
press the Data 3 / –/+ key twice. The display will show DATA+2 for 1 second and then
show the button’s number (B__) an additional value it will send.
14. Press the Enter key. The button is now set to cycle through the 3 or 4 assigned MIDI CC
values, and you will exit Edit Mode.
To cancel your changes instead, press Edit. You will exit Edit Mode without saving anything.
Remember to store the preset if you want to save your changes in that preset.
To Next Page
Loading...
Need help?
General
