47
Buttons
This chapter explains how to assign the buttons to different commands. See the Editing
Assignments section to learn how to do this.
The buttons’ functions also depend on their current mode. See the Modes section to learn
about their modes.
Editing Assignments
You can set the channel of each button. See Channel to learn how to do this.
To learn how to assign different types of messages to a button, see the Messages section.
You can also set whether a button is “momentary” (the default) or “latching” (also known as
“toggle”). See the Latching section to learn about this.
While in MIDI Mode or HID Mode, you can customize the color of each button. See Colors to
learn how to do this.
Channel
To set the MIDI channel for a button:
1. Press Edit to enter Edit Mode. The Edit button will light up.
2. Press the desired button. The button’s number will appear in the display.
3. Press the Chan Assign key. The display will show CHN for 1 second and then show the
button’s number and current MIDI channel or zone channel.
4. Use the numeric keys (0–9) or Preset Down/Up () buttons to enter the desired MIDI
channel (00 or 01–16) or zone channel (17–20).
Note: Values 00 and 01–16 correspond to Code 61’s global channel and the 16 available
MIDI channels. Values 17–20 correspond to channels used by Zones 1–4 (z1–z4).
5. Press the Enter key. The button will be assigned to that channel, and you will exit Edit
Mode.
To cancel your changes instead, press Edit. You will exit Edit Mode without saving anything.
Remember to store the preset if you want to save your changes in that preset.
To Next Page
Loading...
Need help?
General
