51
Program, Bank LSB, and Bank MSB
You can set a button to send a combined program number, Bank LSB, and Bank MSB
number. This can be useful for selecting a preset from a specific bank of a virtual instrument or
synthesizer (the instrument or synthesizer must support these messages).
The buttons must be in MIDI Mode to do this (see Modes > MIDI Mode).
To assign a button to send a combined program, Bank LSB, and Bank MSB number:
1. Press Edit to enter Edit Mode. The Edit button will light up.
2. Press the desired button. The button’s number will appear in the display.
3. Press the Ctrl Assign key. The display will show ASGN for 1 second and then show the
button’s number (B__) and a number for the type of message it sends.
4. Use the numeric keys (0–9) or Preset Down/Up () buttons to enter 145.
5. Press the Data 1 key. The display will show DATA1 for 1 second and then show the
button’s number (B__) and the program number it will send.
6. Use the numeric keys (0–9) or Preset Down/Up () buttons to enter the desired
program number.
7. Press the Data 2 key. The display will show DATA2 for 1 second and then show the
button’s number (B__) and the Bank LSB number it will send.
8. Use the numeric keys (0–9) or Preset Down/Up (
) buttons to enter the desired Bank
LSB number.
9. Press the Data 3 key. The display will show DATA3 for 1 second and then show the
button’s number (B__) and the Bank MSB number it will send.
10. Use the numeric keys (0–9) or Preset Down/Up () buttons to enter the desired Bank
MSB number.
11. Press the Enter key. The button is now set to send the program number, Bank LSB
number, and Bank MSB number, and you will exit Edit Mode.
To cancel your changes instead, press Edit. You will exit Edit Mode without saving anything.
Remember to store the preset if you want to save your changes in that preset.
To Next Page
Loading...
Need help?
General
