44
Messages
MIDI CCs
You can assign the faders to send MIDI CC messages with values within a specified range.
To assign a MIDI CC to a fader:
1. Press Edit to enter Edit Mode. The Edit button will light up.
2. Move the desired fader. The fader’s number will appear in the display.
3. Press the Ctrl Assign key. The display will show ASGN for 1 second and then show the
fader’s number (F__) and a number for the type of message it sends.
4. Use the numeric keys (0–9) or Preset Down/Up () buttons to enter a MIDI CC number
(001–127).
5. Press the Data 2 key. The display will show DATA2 for 1 second and then show the
fader’s number (F__) and the value at its minimum position.
6. Use the numeric keys (0–9) or Preset Down/Up () buttons to enter a value (001–127).
7. Press the Data 3 key. The display will show DATA3 for 1 second and then show the
fader’s number (F__) and the value at its maximum position.
8. Use the numeric keys (0–9) or Preset Down/Up () buttons to enter a value (001
–127).
9. Press the Enter key. The fader is now set to send the assigned MIDI CC, and you will exit
Edit Mode.
To cancel your changes instead, press Edit. You will exit Edit Mode without saving anything.
Remember to store the preset if you want to save your changes in that preset.
Tip: You can reverse the direction (polarity) of the fader so that its lowest position sends
its maximum value and vice versa. To do this, enter the desired maximum value in Step 5
and the desired minimum value in Step 7.
To Next Page
Loading...
Need help?
General
