89
MIDI CC Value Increment/Decrement
You can set the sustain pedal to increment/decrement a MIDI CC value by 1 each time you
press it. After it reaches its highest or lowest value, it will “wrap around” and start again at its
lowest or highest value, respectively. In other words, pressing the sustain pedal causes the
value to cycle through its entire range by increments of 1.
To assign the sustain pedal to increment/decrement a MIDI CC value:
1. Press Edit to enter Edit Mode. The Edit button will light up.
2. Press the sustain pedal. SUS will appear in the display.
3. Press the Ctrl Assign key. The display will show ASGN for 1 second and then show SUS
and a number for the type of message it sends.
4. Use the numeric keys (0–9) or Preset Down/Up () buttons to enter 154 (to increment a
MIDI CC value) or 153 (to decrement a MIDI CC value).
5. Press the Data 1 key. The display will show DATA1 for 1 second and then show SUS and
the MIDI CC value it will increment/decrement.
6. Use the numeric keys (0–9) or Preset Down/Up () buttons to enter a value (000–127).
7. Press the Data 2 key. The display will show DATA2 for 1 second and then show SUS and
the lowest value it will send.
8. Use the numeric keys (0–9) or Preset Down/Up () buttons to enter a value (000–127).
9. Press the Data 3 key. The display will show DATA3 for 1 second and then show SUS and
the highest value it will send.
10. Use the numeric keys (0–9) or Preset Down/Up () buttons to enter a value (000–127).
11. Press the Enter key. The sustain pedal is now set to increment/decrement the MIDI CC
value, and you will exit Edit Mode.
To cancel your changes instead, press Edit. You will exit Edit Mode without saving anything.
Remember to store the preset if you want to save your changes in that preset.
To Next Page
Loading...
Need help?
General
