34
Zone Bank Change
Zone Bank Change messages are sent on the channel(s) of active zones, thus accessing
additional banks of instrument sound presets (if available) for each zone. Each bank change
consists of an LSB number (Least Signficant Byte) and an MSB number (Most Significant
Byte). These bank change messages are stored in each preset, ensuring that each zone
selects the correct instrument whenever you load a preset.
To set the zone bank change:
1. Press and hold Zone for 1 second to enter Zone Edit Mode. The active Zone Buttons 1–4
will flash.
2. Press one of Zone Buttons 1–4 to edit that zone. Alternatively, you can press multiple
Zone Buttons 1–4 to edit those zones simultaneously.
3. Press and hold Shift, and then press the Bank LSB key. The display will show LSB and
the LSB number.
4. Enter the desired LSB number by doing one of the following:
• While holding Shift, use the numeric keys (0–9) to enter an LSB number (000–127).
• Use the Preset Down/Up () buttons to select an LSB number (000–127).
5. While holding Shift, press the Enter key.
6. While holding Shift, press the Bank MSB key. The display will show MSB and the MSB
number.
7. Enter the desired MSB number by doing one of the following:
• While holding Shift, use the numeric keys (0–9) to enter an MSB number (
000–127).
• Use the Preset Down/Up () buttons to select an MSB number (000–127).
8. While holding Shift, press the Enter key.
9. To set the program change for another zone, repeat Steps 2–8.
To exit Zone Edit Mode, press Zone.
To Next Page
Loading...
Need help?
General
