86
Sustain Pedal
Editing Assignments
You can set the channel of the sustain pedal. See Channel to learn how to do this.
To learn how to assign different types of messages to the sustain pedal, see the Messages
section.
You can also whether the sustain pedal is “momentary” (the default) or “latching” (also known
as “toggle”). See the Latching section to learn about this.
Channel
To set the MIDI channel for the sustain pedal:
1. Press Edit to enter Edit Mode. The Edit button will light up.
2. Press the sustain pedal down and then release it. SUS will appear in the display.
3. Press the Chan Assign key. The display will show CHN for 1 second and then show SUS
and current MIDI channel or zone channel.
4. Use the numeric keys (0–9) or Preset Down/Up () buttons to enter the desired MIDI
channel (00 or 01–16) or zone channel (17–20).
Note: Values 00 and 01–16 correspond to Code 61’s global channel and the 16 available
MIDI channels. Values 17–20 correspond to channels used by Zones 1–4 (z1–z4).
5. Press the Enter key. The sustain pedal will be assigned to that channel, and you will exit
Edit Mode.
To cancel your changes instead, press Edit. You will exit Edit Mode without saving anything.
Remember to store the preset if you want to save your changes in that preset.
To Next Page
Loading...
Need help?
General
