64
Modes
The encoders are always in one of two modes. Press Encoder Mode to switch between
them, distinguishable by the Encoder Mode button’s color.
MIDI Mode
In this mode, the Encoder Mode button will be lit red.
Turning the encoders will send MIDI CC messages, which you can assign (described earlier in
Editing Assignments > Message).
Mackie Control/HUI Mode
In this mode, the Encoder Mode button will be lit green.
If your Code Series keyboard is set to use the Mackie Control protocol, turning the encoders
will adjust the panning of each track.
If your Code Series keyboard is set to use the HUI protocol, turning the encoders will adjust
the panning of each track. In Avid
®
Pro Tools
®
, stereo channels have two panning controls: left
and right. Press the Shift button to switch the encoders between the left channel and right
channel.
Use the Bank Right/Left () buttons to move to another bank of tracks.
To select the Mackie Control or HUI protocol, see Mackie Control and HUI.
Important note if you are using Code 25: In your DAW, it may look like you are controlling 8
tracks, but you can control only 4 tracks at a time. When you press one of the Bank
Right/Left () buttons, you will control only the next/previous 4 tracks.
To Next Page
Loading...
Need help?
General
